Loan

Sep 8 2017

Rebuild Kit NP241 Transfer Case and Parts Illustration, you save money! #rebuild #kit #np241 #transfer


#

NP 241 Transfer Case Repair Parts Rebuild Kits

We are proud to offer top quality professional grade, NP241 transfer case parts and rebuild overhaul kits. We can, in some cases, provide good used parts; these are good take out parts that are inspected.
Chevrolet NP241C Transfer Case Parts and top of the line overhaul kits. The New Process 241 series transfer case was installed in Dodge and Chevrolet applications starting in 1987. Jeep installed them in 2003-2005, these transfer cases are part time Dodge NP241D Transfer Case Parts for four wheel drive with shift positions 4HI – 2HI – N – 4L. The NP231 is 1:1 direct drive in high range, and use planetary reduction gears for low range with a ratio of 2.72:1. This unit is a chain driven front output, The NP 241 is a part-time transfer case and is manual shifted. Give us a call 800-216-1632 and let us help you save time and money!

These New Process cases have a circular tag on the rear of the case, near the center close to where the rear drive shaft exits. Identification information for the NP241 transfer case is on this tag typically includes model number, assembly number, and serial number and ratio data. When ordering a replacement transfer case it’s most important to know the assembly number. This number is typically eight digits, four number a rivet/screw head and four additional numbers.

Jeep, Dodge and Chevy versions all use a 6-bolt circular bolt pattern. This pattern is non-symmetrical and will only bolt up one way. Jeep units and Dodge units are general interchangeable, however Chevrolet units are not. While GM uses the same 6-bolt patter, they have it rotate approximately 90 degrees from that used by Jeep or Dodge.

NP241 transfer cases come with either a 23-spline female input. Some Dodge one ton heavy-duty units have 29 splines. The 27-spline shaft is found in applications that use the TH350, 4L60E and 700R4 transmission. With the Th400 and 4L80E or manual 5 speeds are supplied with 32 spline. Now would also be a good time to install our transfer case saver to prevent rear snap ring failure.

A cross-reference table is provided below to help you in identification of your transfer case. Check tag found on rear of unit for model no. An illustrated drawing is provide below to help you in parts identification, ordering and assembly. Back to other model transfer case parts availability page. Don’t see the thing you need just give us a call toll free 800-216-1632. If you decide to replace your NP 241 transfer case with a remaufactured unit with a 12 month warranty see our complete list of transfer cases for Chevrolet/GMC, Dodge and Jeep vehicles. All rebuilt transfer cases get new seals, bearings, chains, fork pad. All shafts, slider, hubs and planets are inspected to ensure proper factory tolerances are maintained. All units are tested inside the factory prior to shipment.
New Process Model 241

Part-Time Transfer Case Manual Shift


Written by admin


Leave a Reply

Your email address will not be published. Required fields are marked *